Skim Coat Basement Floor
Skim Coat Basement Floor – Flooring Guide by Cinvex
Skim Coat Basement Floor – Flooring Ideas
Skim Coat Concrete Basement Floor
Skim Coat Concrete Basement Floor
Skim Coat Concrete Basement Floor – Flooring Ideas
Skim Coat Basement Floor – Flooring Site
Skim Coat Basement Floor – Flooring Guide by Cinvex
Skim Coat Concrete Basement Floor
Skim Coat Basement Floor – Flooring Site
11 Concrete skim coat basement ideas flooring, cement floor, concrete floors
Skim Coat Basement Floor – Flooring Site
Related Posts:
- Brick Basement Flooring
- Budget Basement Flooring
- Waterproofing Your Basement Floor
- Laminate Basement Flooring
- Basement Floor Design Ideas
- Vinyl Tile For Basement Floor
- Redo Basement Floor
- DIY Concrete Basement Floor
- Gravel Basement Floor
- How To Clean Basement Cement Floor
Basements are often the forgotten corner of any home. Even though they may be used as storage rooms and laundry rooms, they often lack the style and design of other rooms in the home. But what if you could give your basement floor a makeover? Skim coating is the perfect way to update your basement floor, giving it a fresh, modern look.
Skim coating is a process that involves applying thin layers of a mixture of cement, sand, and water over a concrete surface. The mixture is applied in thin layers, which are then troweled down until they are smooth and even. This process is often used to level out uneven surfaces or repair cracked or damaged concrete. It can also be used to give a basement floor a more modern look.
When skim coating your basement floors, it’s important to take the time to prepare the surface properly. This includes cleaning the floors with a pressure washer and using a degreaser to remove any oil or grease stains. Once the surface is cleaned and prepped, you’ll need to apply an etching solution to open up the pores of the concrete and allow for better adhesion of the skim coating mixture.
Once your surface is prepared and ready to go, it’s time to mix up your skim coating mixture. This mixture should be made up of one part Portland cement, three parts sand, and enough water to create a thick paste-like consistency. You’ll then need to apply this mixture in thin layers over the entire surface area of your basement floors. It’s important to make sure that each layer is completely dry before applying the next layer. Applying too much pressure when troweling can cause air pockets and lines in the concrete, so it’s best to use light pressure and long strokes when troweling.
Once all of your layers are applied and troweled down, it’s time for the finishing touches. You can either seal your basement floor with an epoxy sealer or leave it as is for a matte finish. If you plan on sealing your floor, you’ll need to wait until the skim coat has completely dried before applying two coats of sealer. Sealing will protect your concrete from moisture damage as well as give it a nice shine.
Skim coating is an easy and cost-effective way to give your basement floor a facelift. Not only does it make the floor look better, but it also helps protect against moisture damage and makes it easier to clean. With just a few simple steps you can have your floors looking like new in no time at all!